forums.silverfrost.com

[mbly]

MikeHi
Is there any way to increase the allocatable memory, heap beyond 100 mb to allow for larger arrays? Currently , I can only do 2 arrays of size: (500000,200). Any suggestions? If so, can you walk a newbie through it. If not, any recommendations?
thanks

[JohnCampbell]

You should use ALLOCATE for these arrays.

[mbly]

Thanks for the reply.

Isn't ALLOCATE used mainly to help in the definition of a dynamic array?

Won't I still be limited by the 100mb heap or stack?

thanks
Mike

[JohnCampbell]

Allocate uses the malloc memory routines and not the heap or stack. Local variables and automatic arrays use the stack.
After many years of programming, i still do not know what the "heap" is or how big it needs to be.
With FTN95 on a 64-bit OS, you can allocate an array up to nearly 2gb in size.
Give it a try and you will find the flexibility very effective, especially if you declare these arrays in a module, so that they are globally available.

John

[davidb]

The "heap" is where malloc (in C) and allocate (in Fortran) allocates memory.

Strictly speaking the heap doesn't have to be used in Fortran for this, but it usually is.

I don't think you can change the maximum size of the "normal" heap with Silverfrost's FTN95. You can set the maximum size of the "check heap" used in check mode using an environment variable FTN95CHECKHEAP.

There's some information in the documentation.
_________________
Programmer in: Fortran 77/95/2003/2008, C, C++ (& OpenMP), java, Python, Perl

[JohnCampbell]

David,

I am able to allocate arrays anywhere in memory, from about 4mb to 4gb, where the space is available. I don't think this "heap" really exists as a location in memory. When using ALLOCATE, there must be some memory management table to indicate what is being used. Perhaps the memory table is in the "Heap".
Help on "Storage management routines" does describe a 100mb area above the stack, so perhaps this is just the top of the stack.
I have had more experience with the "stack", which is used for local and automatic arrays. This experience has taught me not to use it, except for variables or very small arrays.
I place all large (not small) arrays in COMMON, modules or as allocatable arrays, with my preference now being for allocatable arrays in modules.

John

[davidb]