forums.silverfrost.com

[Konstantin8]

Try to build a program with Output profile information.
During the process two problem occur:
1. during compiling program.f95 I see the following:
Access violation:
The instruction at address 561af000 attempted to read from location 561af000
561af000 routine at address 561AF000 [+0000]

eax=055d32e4 ebx=20202020 ecx=000006bd
edx=0000000a esi=20202020 edi=20202020
ebp=20202020 esp=03cee9e4 IOPL=0
ds=002b es=002b fs=0053
gs=002b cs=0023 ss=002b
flgs=00210297 [CA EP NZ NS DN NV]
0360/0820 TSTK=1 [ ]

2. and then, at the end of the log:
Could not open Program.obj.


I upgraded from 6.10 to 7.00 but the problem still exists.

[PaulLaidler]

Is the program short enough to post here?

[Konstantin8]

Hello,
No, program is big.
I've just post an example with "Program" name.
I can post the begining (with declaration of variables).
But the problem is reproduced only with Output profile option.